The Ford Barn - View Single Post

Purdy Swoft · 06-09-2019, 12:21 PM

The one piece pulley that failed for me was caused by problems with the front motor mount yoke . I ended up disconnecting and removing the headlamp bar and headlamps . I also removed the radiator . I almost needed to remove the engine to get the needed clearance to remove the broken pulley . When the two piece pulley is used , if the pulley is the same style, only the outer part will need to be removed and replaced and no other parts will have to be removed .

06-09-2019, 12:21 PM	#7
Purdy Swoft Senior Member Join Date: May 2010 Location: Alabama Posts: 8,099	Re: Two piece crank shaft pulley The one piece pulley that failed for me was caused by problems with the front motor mount yoke . I ended up disconnecting and removing the headlamp bar and headlamps . I also removed the radiator . I almost needed to remove the engine to get the needed clearance to remove the broken pulley . When the two piece pulley is used , if the pulley is the same style, only the outer part will need to be removed and replaced and no other parts will have to be removed .