The Ford Barn - View Single Post - Specific questions re using a boring bar (Old school)

Mart · 12-12-2019, 03:28 PM

Thanks Russ. Test bores taking place currently. Videos will be following along.
There will be a new one tomorrow showing the first stage of the prep for the test boring.

Thanks Ronnie. All good points. I hadn't considered a honing plate. If I ever do anything other than trying to get this one motor to run again I will certainly think about it.

Mart.

12-12-2019, 03:28 PM	#16
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,743	Re: Specific questions re using a boring bar (Old school) Thanks Russ. Test bores taking place currently. Videos will be following along. There will be a new one tomorrow showing the first stage of the prep for the test boring. Thanks Ronnie. All good points. I hadn't considered a honing plate. If I ever do anything other than trying to get this one motor to run again I will certainly think about it. Mart.