The Ford Barn - View Single Post

19Fordy · 11-13-2020, 10:18 AM

V8: Rather than removing the X Member center piece, why not cut it out with the laser even with the edges of the top and bottom frame flange. This would leave the riveted rails of the removed X member in place providing a little more rigidity. Grind edges smooth.

11-13-2020, 10:18 AM	#14
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,950	Re: transmission question V8: Rather than removing the X Member center piece, why not cut it out with the laser even with the edges of the top and bottom frame flange. This would leave the riveted rails of the removed X member in place providing a little more rigidity. Grind edges smooth.