The Ford Barn - View Single Post

bobv · 12-16-2013, 06:11 PM

I have a front brake hub/drum that I would like to have turned to clean it up. It doesn't have bearings or races in it. Can this be done without the races installed?
Is there an acceptable amount of out of round?
Thanks

12-16-2013, 06:11 PM	#1
bobv Senior Member Join Date: May 2010 Location: Baxter, MN. Posts: 120	Turning a brake drum I have a front brake hub/drum that I would like to have turned to clean it up. It doesn't have bearings or races in it. Can this be done without the races installed? Is there an acceptable amount of out of round? Thanks