The Ford Barn - View Single Post

AnthonyG · 12-05-2019, 02:23 PM

Will b interesting 2 follow. Ur Flatty has bell housing is cast on engine type as all pre ‘49’s R, Ur pic’s made me think I might be able to mount my 8BA the same using mounted bell to bolt to my indexing engine stand, thoughts? I’m not removing my crank so see no reason to remove bell housing, FW, clutch or PP?

12-05-2019, 02:23 PM	#4
AnthonyG Senior Member Join Date: May 2013 Location: Pa. Posts: 2,174	Re: Engine Made in the Stand Will b interesting 2 follow. Ur Flatty has bell housing is cast on engine type as all pre ‘49’s R, Ur pic’s made me think I might be able to mount my 8BA the same using mounted bell to bolt to my indexing engine stand, thoughts? I’m not removing my crank so see no reason to remove bell housing, FW, clutch or PP? __________________ Nomad