View Single Post
Old 07-28-2017, 11:40 PM   #1
Daves55Sedan
Senior Member
 
Daves55Sedan's Avatar
 
Join Date: May 2010
Location: Granite City, Illinois
Posts: 3,008
Default 55/56 Sedan door gaskets

I know I have seen this bounced around here on fordbarn a few times in the last many years, yet I don't know if we've ever really come up with a fix.
These darned Dennis Carpenter door gaskets are terrible. I put a new set on my car in 1993 and put a set on my Courier wagon in 1998.
Both sets have shrunk so much that they don't even touch the doorjamb at the top and rain splashes in, soaking the seat upholstery and leaves puddles on the rubber floor mat.

The car has always been outside these last 45 or so years, but the Courier has mostly been parked in the garage, so if exposure to the elements is the excuse to fault these gaskets, I would be forced to testify that it does not take very much exposure to ruin the gaskets. I believe they are basically worthless.
I have tried to supplement them with stick on foam rubber, but that is not very helpful since the gaskets shrink in both horizontal and vertical measurements. The gaskets at both the top and bottom are deficient in height to begin with, comparing to the original gaskets and to have them shrink only adds to the problem.
Has anyone found anything to help stop the water from coming in? I don't care if its complete gasket replacement with something better, or something to supplement the substandard gaskets.
Daves55Sedan is offline   Reply With Quote