View Single Post
Old 08-17-2018, 05:51 PM   #1
Minn-Tex Lee
Senior Member
 
Minn-Tex Lee's Avatar
 
Join Date: May 2010
Location: Stewrtvl MN-Fredbrg TX
Posts: 184
Default Shifter tower gasket question

I am replacing the tower and after making a new gasket for the tower / body surface I notice there is no gasket on the vertical surface where the two plungers slide in.
Is this correct or do I need to make a gasket for that surface?
Thanks
Lee
Minn-Tex Lee is offline   Reply With Quote