The Ford Barn - View Single Post

deuce_roadster · 04-09-2018, 10:42 AM

I reproduced these a few years ago and no longer have any but I think I have a picture. I will post again after looking through my stuff. It is more complicated then it looks as the back of it has the bevel of the header, both across and at the very top a little of it bevels back and the hole has to be at the right angle to come out in the right spot. I made these out of cast stainless that could be polished so no chroming would be needed.

Update, click on my avatar and look through my 40 woodie picturs and there is one that you can see most of 1/2 of the bracket you seek. I am sure 38-40 would use the same one as that part of the cowl was the same.

04-09-2018, 10:42 AM	#5
deuce_roadster Senior Member Join Date: Oct 2011 Location: Shelton, WA Posts: 3,800	Re: 1938 Ford Woody Station Wagon I reproduced these a few years ago and no longer have any but I think I have a picture. I will post again after looking through my stuff. It is more complicated then it looks as the back of it has the bevel of the header, both across and at the very top a little of it bevels back and the hole has to be at the right angle to come out in the right spot. I made these out of cast stainless that could be polished so no chroming would be needed. Update, click on my avatar and look through my 40 woodie picturs and there is one that you can see most of 1/2 of the bracket you seek. I am sure 38-40 would use the same one as that part of the cowl was the same.