View Single Post
Old 11-25-2019, 07:54 AM   #17
glennpm
Senior Member
 
glennpm's Avatar
 
Join Date: Sep 2014
Location: Wiscasset, Maine
Posts: 1,965
Default Re: 47 generator rear bushing

I replaced the bushing in my three brush generator a couple of months ago. I bought the bushing from Vanpelt and used a internal bearing puller to get the old one out. I supported the end plate on the top on my vise and used the slide hammer to pull the bushing out from below. It was stubborn at first, but then once moving came out easily.


http://www.vanpeltsales.com/FH_web/v...atalog2019.pdf


<div>

Last edited by glennpm; 12-01-2019 at 09:26 AM.
glennpm is online now   Reply With Quote