Thread: 1930 CCPU seats
View Single Post
Old 02-22-2012, 06:37 PM   #3
Herb Concord Ca
Senior Member
 
Join Date: May 2010
Location: Concord CA
Posts: 397
Default Re: 1930 CCPU seats

Hi Mary, welcome to fordbarn.
On my '31CCPU, my seat back has 2 brackets with a dog leg that allow the seat back to be slightly behing the upper wood cross bar bolted to the sheetmetal. The brackets are screwed into the wood crossbar. This holds the top of the seat cushion in place.
I don't have the lower pointy brackets like in your picture, in fact I don't have any lower brackets. The lower seat back is held in place by the seat cushion.
I added a piece of wood furing (SP?) strip to give a slight tilt to the seat back rather than being striaght, this feels better for me than being vertical.
Don't know if this is correct but it's the way my seat was installed when I got my truck in 1992.
Hope this helps.
Regards,
herb neumann
Diablo A's
Herb Concord Ca is offline   Reply With Quote