Quote:
Originally Posted by DavidG
Nope, not there yet. You have to add one of the two short S-shaped pipes (that are at the bottom of your earlier photo) at the back end of your photo on the right. The back end of the long pipe in your latest photo and the short S-shaped pipe join together at the front right corner of the rear cross member with the short pipe passing through the hole in the front vertical surface of that cross member. There's a unique-to-'32 clamp for that junction of the two pipes shown on page 4-39 of the book.
|
One of these? Correct?
1. these seem to be all new. The are rusty but not as bad as they look. Would you clean these with acid and paint them with bbq grill paint maybe?
2. Without a doubt i have those clamps but probably wont be able to find them. Is this stuff i can buy?
3. The flywheel in the picture i can use acid to clean this but i shouldnt sand blast it, correct?
I got the pictures they are perfect, Thanks!