View Single Post
Old 12-18-2018, 06:55 PM   #8
HalcyonDays
Senior Member
 
HalcyonDays's Avatar
 
Join Date: Oct 2014
Location: Maine
Posts: 224
Default Re: Rebuilding Zenith Carburetor

Thank you all for the suggestions.



Good news is the baby survived the operation!



I tried all of the above, soaking in carb cleaner, soaking in penetrating oil, (both over night), then heat, (did not dip in cold water as I was afraid of cracking carb.), then I tore up the head pretty good after all these attempts. Finally drilled, easy-outed, and then re-tapped.


Turned out very well. On to next step.


Thanks again
HalcyonDays is offline   Reply With Quote