The Ford Barn - View Single Post

Roger V · 03-28-2015, 10:00 AM

Never had a problem either with pulling/replacing many engines via the spark plug holes. My preferred method is #1 and #4 with "L" brackets special made to center over the engine using Stipe's plug hole studs. I use a leveler (BTW some are too long for a Model A) since the angle going in to clear the front cross member is steeper than what is needed to mate to the torque tube.

03-28-2015, 10:00 AM	#12
Roger V Senior Member Join Date: May 2010 Location: Michigan Posts: 1,593	Re: Plug hole engine lift Question Never had a problem either with pulling/replacing many engines via the spark plug holes. My preferred method is #1 and #4 with "L" brackets special made to center over the engine using Stipe's plug hole studs. I use a leveler (BTW some are too long for a Model A) since the angle going in to clear the front cross member is steeper than what is needed to mate to the torque tube.