The Ford Barn - View Single Post - 36 bumper thickness for trunkback convertibles sedan

36 CS · 09-19-2016, 12:14 PM

Question 1---I have two thickness of front bumper outside support brackets for the passenger side, approx.1/4" and 3/8". Are the reproduction 1/4 and the original Ford 3/8? The inside bracket is 1/4. This is for a 36 trunkback conv. sedan. If it is 3/8 then I would need one for the drivers side. Any help would certainly be appreciated.

Question 2---This is for the above car also. Is there a rubber pad that installs between the rear bumper bracket and car?

09-19-2016, 12:14 PM	#1
36 CS Senior Member Join Date: May 2010 Location: Gulf Coast of Alabama Posts: 147	36 bumper thickness for trunkback convertibles sedan Question 1---I have two thickness of front bumper outside support brackets for the passenger side, approx.1/4" and 3/8". Are the reproduction 1/4 and the original Ford 3/8? The inside bracket is 1/4. This is for a 36 trunkback conv. sedan. If it is 3/8 then I would need one for the drivers side. Any help would certainly be appreciated. Question 2---This is for the above car also. Is there a rubber pad that installs between the rear bumper bracket and car?