The Ford Barn - View Single Post

phoenix5x · 05-19-2017, 05:44 AM

Mark the input shaft and the rear axle at a starting point. Then spin the input shaft 3 complete revolutions. If your axle spins about 1/2 of the way around probably have a 3.54. Larger ratios you might have to reduce that fraction..not precise but gets ya an idea

Sent from my VS995 using Tapatalk

05-19-2017, 05:44 AM	#2
phoenix5x Junior Member Join Date: Dec 2010 Posts: 4	Re: Checking rear ratio Mark the input shaft and the rear axle at a starting point. Then spin the input shaft 3 complete revolutions. If your axle spins about 1/2 of the way around probably have a 3.54. Larger ratios you might have to reduce that fraction..not precise but gets ya an idea Sent from my VS995 using Tapatalk