Quote:
Originally Posted by Mart
If it is wired right, there is a problem in the lighting circuits causing the fuse to blow, and you are right, the fuse blowing would not stop the ignition from working.
Coincidentally, Frank, your coil is visible in the top of that pic. You were asking about that before. It may be worth looking at both the HT and low tension wires to and from that coil.
(I wrote this as a reply to the last post on page 2, missed the posts above.)
Frank, it's worth getting a "headlight" type flashlight that sits on a strap round your forehead. Very helpful when working in these out of the way areas.
Mart.
|
I appreciated your good advice before and replaced the HT wire because it as badly crystallized and insulation was off inseveral places and it broke as I twisted it. It thought that may be it.
But had to replace it anyway. Replaced the coil and condenser too.