Quote:
Originally Posted by done4
More progress and more fun watching. Did you video the steps of grinding down the cylinder liners for the intake and exhaust valley. Just curious how that went and how long it took?
|
Hi done4 thanks for watching.
That process is covered in next weeks episode. It wasn't difficult and didn't take long. I recently bought a die grinder and a selection of carbide burrs. I did a job that I was happy with for this engine. I suspect some might prefer something a bit smoother, but I am happy with it.
I say all that, but I did make a couple of little slips that I wasn't too pleased with. It's all in the next vid.
Mart.