Re: What is this nut on the right side of the engine block?
That is a plug, a pipe plug 1/8 - 27 . Try to tighten it, it could be that at one time some one put a bolt in there and distorted the threads. I looked closer at your photo, it looks like you have the oil pump holding tool installed in that threaded port, unscrew the large part of it and install a 1/8 - 27 pipe plug. All the vendors have this part, a hardware store will have it too.
Last edited by Drive Shaft Dave; 04-11-2018 at 09:26 PM.
|