Quote:
Originally Posted by juke joint johnny
I haven't found one of these engines yet but I am always looking.
Is there anyone who sell's the Shell bearings for the G28T engine ?
Do the Shells sold to convert the earlier B with Babbit bearings work on them?
Would the steel B oil pan fit one?
John Cochran
|
Ron Cloat has one of these engines for sale.
No one sells replacement bearing shells for the G28T that I know of. A fixture would likely need to be made to hold the shells where babbitt could be poured and then machined.
The shells that Rich Falucia sells with not work. I think someone could line-bore the block and possibly use a small block Chevrolet rod bearing in tandem in the main saddle bores. The rod pins could be offset machined to either accept a new A or B rod which if a different piston was used could make a stroker motor.