View Single Post
Old 11-25-2011, 09:13 AM   #3
Terry,OH
Senior Member
 
Terry,OH's Avatar
 
Join Date: May 2010
Posts: 4,725
Default Re: Picture of a tailpipe bracket 39

The final exhaust clamp 99A-5261 is the same for 39 85 HP pick up and passenger and 40 85 HP pick up and passenger. I am not aware of anyone making a reproduction of this bracket. It is one piece, the clamp (angled) is welded to a short round rod that extends into a round rubber block and is vulcanized to the rubber, coming out of the rubber, on the opposite side, is another round rod that is again vulcanized into the rubber and threaded at the final end. The threaded end of this rod is inserted into a hole in the frame and held to the frame by a lock washer and nut, the angled clamp hangs down and accepts the tail pipe.
Attached Images
File Type: jpg DSC01972.JPG (58.5 KB, 56 views)

Last edited by Terry,OH; 11-25-2011 at 09:26 AM.
Terry,OH is offline   Reply With Quote