Thread
:
Milling a head for compression?
View Single Post
09-22-2011, 10:59 PM
#
2
Tom Wesenberg
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Re: Milling a head for compression?
You couldn't mill the stock head enough to raise the compression enough to matter. Best to just buy the high compression head. Milling at an angle would ruin the head.
Sponsored Links (Register now to hide all advertisements)
Tom Wesenberg
View Public Profile
Send a private message to Tom Wesenberg
Find More Posts by Tom Wesenberg