[FrankWest]

Again, I appreciate everyone;s help.
I am in a holding mode until a solution turns up.
I am in no hurry.... I don;t want to ruin anything.
Here is a list of possible solutions...Some are silly but I am trying to brainstorm

fix considerations
1) Try to remove crank pulley
a) Can they usually be removed after 80 years? Or are pins and bolts frozen.
If break then can I obtain replacement.
What if damage shaft....will I have to replace crank shaft?

2) Cut engine support bracket.
Can I find replacement?
Can it be installed? If I can't remove existing one from between ledges on timing cover, Crank pulley, engine oil pan lip...Then how can I insert new bracket in place?

3) with Hack saw Cut off ledgers on Timing cover.
Still have problem, Can bracket fit past
Timing cover dimple for timing gear end bearing "protrudes approx 1 inch Why??? Perhaps can file down approx 1/4 in or so to allow bracket to slide through.

4) Cut engine support bracket.
Can I find replacement?
Replace old timing cover with newer one without ledges that Ford produced in 1935. Will this newer Timing cover work on the older 1933 engine???

5) and best just thought of it.
A shallow socket wrench with tapered neck may fit under bracket to undo the last bolt