The Ford Barn - View Single Post

qstott · 04-03-2016, 06:47 PM

Tom, I'm not using the wireless plates. I will get a photo later and post it.

While looking for a rotor button, I found some motorcraft points and condenser. I've been a Ford parts guy for over 40 yrs. Imagine my anguish when I discovered the DP-104 points have been discontinued and the condensers are in short supply. I bought a couple of sets for my father about 3 years ago. I should have stocked up then.

I may just put the original plate back in it and try that.

Art, the fuel line was good. I just installed a gas tank valve and cleaned the sediment bowl. There was very little gunk in the carb or bowl.

It is backfiring through the carb. I think.

04-03-2016, 06:47 PM	#18
qstott Senior Member Join Date: Mar 2016 Location: Wilson NC Posts: 113	Re: Timing question again! with Pic Tom, I'm not using the wireless plates. I will get a photo later and post it. While looking for a rotor button, I found some motorcraft points and condenser. I've been a Ford parts guy for over 40 yrs. Imagine my anguish when I discovered the DP-104 points have been discontinued and the condensers are in short supply. I bought a couple of sets for my father about 3 years ago. I should have stocked up then. I may just put the original plate back in it and try that. Art, the fuel line was good. I just installed a gas tank valve and cleaned the sediment bowl. There was very little gunk in the carb or bowl. It is backfiring through the carb. I think.