The Ford Barn - View Single Post

tubman · 11-10-2015, 10:21 AM

I am in the process of building a 258" engine for my "t" tub. I had two crankshafts that had been stored on the floor on their sides wrapped in plastic for at least 20 years. I took them both to the machine shop to be checked and have the best one prepped to use. It turned out that the were both good, so we decided to use the one that looked the best, which cleaned up at .010-.020. Knowing that there is some controversy about storing crankshafts, I asked the machinist to check them both for run-out. He said both were less than .003, and in any event, turning them .010 or more would render even that small amount of no consequence.

11-10-2015, 10:21 AM	#1
tubman Senior Member Join Date: Dec 2013 Location: Minnesota, Florida Keys Posts: 10,320	Another myth put out to pasture I am in the process of building a 258" engine for my "t" tub. I had two crankshafts that had been stored on the floor on their sides wrapped in plastic for at least 20 years. I took them both to the machine shop to be checked and have the best one prepped to use. It turned out that the were both good, so we decided to use the one that looked the best, which cleaned up at .010-.020. Knowing that there is some controversy about storing crankshafts, I asked the machinist to check them both for run-out. He said both were less than .003, and in any event, turning them .010 or more would render even that small amount of no consequence.