Re: I could not sit idle, have a new project
Brent, while I remain active in the land speed record body build, we both have been taking a step back to learn the nuances of gas welding aluminum panels. My speedster project has given me great impetus in accelerating my own learning curve in that area.
I have ordered a Meco Midget torch from the 'tinman' along with the smaller hoses to go with the small two stage regulators that I already have. While in Huntsville, I had an opportunity to use this setup and actually ran several 12" long beads with them and it gave me some additional confidence. After welding these panels, I hammered a 3/4" 'bump' in BOTH directions, I repeatedly ran them thru the planishing hammer and the English wheel and found NO cranks or any form of inclusions, giving me greater confidence in the ability to make aluminum panels for competitive and vibratory environments.
__________________
Uncle Bud says "too soon old, too late smart!"
|