View Single Post
Old 02-09-2011, 04:22 AM   #15
FlatheadTed
Senior Member
 
FlatheadTed's Avatar
 
Join Date: May 2010
Location: Auckland
Posts: 4,262
Send a message via AIM to FlatheadTed
Default Re: Fuel pump oddity

with a straight edge across the stand mounting behind the push rod You turn the moter over,The rod should move up just over 1/4 I think 2 tenths of a inch which reflects the pump cam size on the cam shaft .You can mark it with a marker,The amount the rod is sitting above the manifold ,at its lowest point should be the same length as the mounting flange to your pump cup , you can check this by putting something like a screw driver in the cup of your pump and push it to take the slack out from the light spring.Then mark it with a marker .
__________________
http://www.flatheadted.com
FlatheadTed is offline   Reply With Quote