The Ford Barn - View Single Post - Simple DIY distributor/ignition bench tester

tubman · 01-13-2020, 01:33 PM

I've toyed around with doing this using a 12-speed kitchen blender as a starting point. I have been looking for an acceptable subject at various garage sales, but haven't found one yet (I'm not planning on spending any appreciable amount of cash on this "project" for obvious reasons).

01-13-2020, 01:33 PM	#3
tubman Senior Member Join Date: Dec 2013 Location: Minnesota, Florida Keys Posts: 10,312	Re: Simple DIY distributor/ignition bench tester I've toyed around with doing this using a 12-speed kitchen blender as a starting point. I have been looking for an acceptable subject at various garage sales, but haven't found one yet (I'm not planning on spending any appreciable amount of cash on this "project" for obvious reasons).