The Ford Barn - View Single Post - new engine start-up problems

Ggmac · 09-24-2020, 05:23 AM

Agree sounds like too much fuel ! Eliminate the outer carbs from the break in procedure before you wash out the rings . Change manifold if possible or completely block off carbs .
More info needed , volts to coil , type of coil , still 6 volt or changed to 12 .
What kind of tach ? What fuel pump ? Still using a resistor?

09-24-2020, 05:23 AM	#3
Ggmac Senior Member Join Date: Jul 2016 Location: Lake worth Florida Posts: 1,086	Re: new engine start-up problems Agree sounds like too much fuel ! Eliminate the outer carbs from the break in procedure before you wash out the rings . Change manifold if possible or completely block off carbs . More info needed , volts to coil , type of coil , still 6 volt or changed to 12 . What kind of tach ? What fuel pump ? Still using a resistor?