The Ford Barn - View Single Post

Ed Wendell · 06-30-2019, 05:43 PM

Printer,
I was able to pull a tiny wire brush through mine to clean it out. I used RuGlyde (NAPA) rubber lube when pulling in the new gasket. IMPORTANT--let the gasket relax for several hours after you pull (stretch) it in place before you miter the corners or you may end up with a gap later on.
When you order the new gaskets don't forget the hinge gasket at the top, you will most likely want to replace it also.

06-30-2019, 05:43 PM	#3
Ed Wendell Senior Member Join Date: Mar 2011 Location: San Diego, CA Posts: 149	Re: Windshield gasket replacement Printer, I was able to pull a tiny wire brush through mine to clean it out. I used RuGlyde (NAPA) rubber lube when pulling in the new gasket. IMPORTANT--let the gasket relax for several hours after you pull (stretch) it in place before you miter the corners or you may end up with a gap later on. When you order the new gaskets don't forget the hinge gasket at the top, you will most likely want to replace it also.