Thread
:
Motor not aligned with crank hole
View Single Post
03-01-2012, 05:49 AM
#
2
Tom Wesenberg
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Re: Motor not aligned with crank hole
Did you loosen the 4 rear motor mount bolts and tighten the bottom front motor mount bolt? That should pull the front down until the crank slips into the ratchet bolt on the crankshaft.
Sponsored Links (Register now to hide all advertisements)
Tom Wesenberg
View Public Profile
Send a private message to Tom Wesenberg
Find More Posts by Tom Wesenberg