The Ford Barn - View Single Post

Nosetime · 11-16-2017, 08:39 AM

I just did this, after all the usual advice, soaked with Kroil over week or two, MAP gas heat , tapping on studs, still broke 5. TIG is the best way, but even then we tried 3 times on one of the long water outlets and no go. I think we found a trick. Modified one of the tools for air hammer, set it on low, then heated around stud and started LIGHT vibration. You could just see the Kroil going right into stud, amazing. Did that a few times and out it came. Patience is the best tool in the box.

11-16-2017, 08:39 AM	#4
Nosetime Senior Member Join Date: May 2017 Location: Huntington Beach, Calif Posts: 330	Re: getting out stuck head studs I just did this, after all the usual advice, soaked with Kroil over week or two, MAP gas heat , tapping on studs, still broke 5. TIG is the best way, but even then we tried 3 times on one of the long water outlets and no go. I think we found a trick. Modified one of the tools for air hammer, set it on low, then heated around stud and started LIGHT vibration. You could just see the Kroil going right into stud, amazing. Did that a few times and out it came. Patience is the best tool in the box.