View Single Post
Old 09-18-2010, 10:10 AM   #14
BCCHOPIT
Senior Member
 
BCCHOPIT's Avatar
 
Join Date: May 2010
Location: Torrington, CT
Posts: 609
Default Re: Lighten an A flywheel

Quote:
Originally Posted by BRENT in 10-uh-C View Post
You are putting words into my mouth that I did not say because I never stated they couldn't explode! You are also comparing apples-to-oranges in my opinion. We are not speaking of SB Chevrolet engines, we're not turning 6000 rpms, ...and please explain the picture of the pump being driven off the back of the camshaft where the stock flywheel would normally reside. "Most likely" there is more to that story than what you are eluding to. Bottom line is if you do not feel comfortable with my flywheel or how I have used it, then kindly move on and your opinions reserved.

I dont know any thing about the pic. I was looking for one I saw about a year ago with a much lower hp engine but could not find. I dont mean to put words in your mouth and dont wont to start any think becouse I like reading your posts. you all ways have lots of info to share
Bill




.

Last edited by BCCHOPIT; 09-18-2010 at 11:30 PM.
BCCHOPIT is offline   Reply With Quote