Re: Basic advice
Thank you, I will try that, I hadn't thought to use a meat thermometer I'll try that tomorrow if I get home in time, as for the carb leak the two half's are warped and the float was cracked I sanded the bottom half with 800 grit sand paper against a 1in. Sheet of metal I got it flat, but I don't know how to sand the top half as I don't have a mill to set it in, I read somewhere that you could put two gaskets in and take up the space, and as for the oil leak, could I clean up the outside and put a bead of high temp rtv down where the two meet?
|