View Single Post
Old 02-11-2018, 12:12 AM   #19
40 Deluxe
Senior Member
 
Join Date: May 2010
Location: now Kuna, Idaho
Posts: 3,774
Default Re: Replacement Ignition Coil

Quote:
Originally Posted by Bob Bidonde View Post
The replacement ignition coil sold by Model A parts suppliers is a Standard Motor Products UC14T.
http://ecatalog.smpcorp.com/STD/#/ve...m/UC14T?type=s
Does anyone have the output voltage spec for this coil?
Answer: It depends!......Depends on how much voltage is needed to jump the plug gap. If only 5,000 volts will fire the plug, that is all the coil will put out. Even if you have a double super whammy "40,000 volt" coil it will still only build up secondary voltage to the point where the spark is strong enough to jump the plug gap, which will never reach 40,000 volts on a Model A, or any stock engine (unless you have totally burned out plug electrodes or open wires, etc.). An ultra high compression or supercharged engine running at wide open throttle may need this much voltage capability, though.
To test coil output, try a "Lisle #20700 Spark Tester". Or, go to a shop with a scope, hook it up and pull a plug wire off and watch the screen.
40 Deluxe is offline   Reply With Quote