View Single Post
Old 09-08-2018, 09:49 AM   #13
daveymc29
Senior Member
 
daveymc29's Avatar
 
Join Date: Sep 2010
Location: Danville, CA
Posts: 1,315
Default Re: Hood Center Rod Diameter

I had bad luck with the center tube and the drill motor. I did it quite slowly and carefully with a goodly dash of sewing machine oil to lube it up. About half way out it grabbed and looked like the remains of the old can lids that you took off with a key. (Remember the old tuna cans?) replaced with stainless from Bratton's.
daveymc29 is offline   Reply With Quote