Aug/Sept project 2 to make 1 39 std cpe on sdn pan
Hi: youall will enjoy my misery, as I put this worn out cpe on a nice solid sdn pan. Both 39 Std's;The cpe was destined to be a race car until the sedan was found with a salvage title and a solid floor. I've never done this, but plenty of local V8ers have, sooo this a start post and I am 3weeks behind schedule as it is an outside job. Any advise is good and youall will get updates. I am using the sdn cowl and header- plan to cut just above the wiper towers as the sdn roof is higher, then cut at the rear fender mount points curve. Later Newc
|