The Ford Barn - View Single Post

Rand · 02-29-2020, 09:27 PM

I have one 6 volt solenoid fused wire to hot side of the starter solenoid, the other terminal of the solenoid to a ground. Messing with it today I broke the OD cable where it mounts to the lever. so maybe the lever wasn't fully moving as it should? Also I grounded the toggle switch today.
I'm on the hunt for another pull/push OD cable. (anybody have one?)
When I find one I'll report back. Also..When I get it going I will also wire it all up as Henry intended Thank you everybody!

02-29-2020, 09:27 PM	#9
Rand Senior Member Join Date: Feb 2011 Location: Buford, GA Posts: 380	Re: 50 Mercury OD problem I have one 6 volt solenoid fused wire to hot side of the starter solenoid, the other terminal of the solenoid to a ground. Messing with it today I broke the OD cable where it mounts to the lever. so maybe the lever wasn't fully moving as it should? Also I grounded the toggle switch today. I'm on the hunt for another pull/push OD cable. (anybody have one?) When I find one I'll report back. Also..When I get it going I will also wire it all up as Henry intended Thank you everybody!