Quote:
Originally Posted by triumphleroy
I have a full set of stock wheels and 55 Ford Full Hubcaps,
These are just a set of aftermarket Rally Wheels similar to Chevrolet rally Wheels.
|
... sorry... I have these reactions when GM is spoken...
Quote:
I am having an small vibration at about 45 mph, and this set of wheels has two bolt patterns so moved them onto this Ford for Diagnostic reasons ?
have had drive shaft balance checked, set pinion angle on rear end, swapped rear center section, changed from 4 cylinder T5 to 8 cylinder T5? Can coast down from 60 with engine shut down and goes through that vibration from 48 mph back through 37 mph worst at 45 mph? Trying to set up Balance with the old Bear Type Balance where it is spun up on the vehicle???
|
These are just suggestions-
Did you actually take the U-Joints out and check? Sometimes they will be dry frozen and will not appear loose. Do yours have grease fittings?
All mounts are good, output shaft bushing/yoke/pinion flange?
Tires out-of-round (they can be shaved)?
__________________
*****
- WHY IS IT ... 
-
... that everything you buy in the grocery store is either wrapped in or contained in plastic but the government doesn't want you to carry it out in a plastic bag?
WONDERING IN W(BY GOD)V ...
DIAGNOSED CDO - (OCD In Correct Alphabetical Order)