View Single Post
Old 03-09-2018, 01:51 PM   #94
hardtimes
Senior Member
 
hardtimes's Avatar
 
Join Date: May 2010
Location: South California
Posts: 6,188
Unhappy Re: Rear Panhard Bar ?

Quote:
Originally Posted by denniskliesen View Post
That's the one. The bearings didn't require a lot of shims so the width was near perfect and the pinion race was a good tight fit also. Btw I adjusted the for the length of the bolts on the sides of the center section to be the same as original bolts so they aren't too long or too short. I don't remember what the provided bolts were as I replaced everything in the kit to grade 8. No problem posting pictures, I just post them direct to this website from my computer.
Hey Dennis,


Thanks for your help ! You young guys, hm. Probably have a lift too, eh ?
Yeah, I had to change out all of the center section bolts also. As you did for strength and length. My center section is a QC, which has coarse threads, not the fine as original. All is well , except my back from crawling under and out from under..umpteen times. No test run today, as can hardly move left leg..bummer !


Let us know how your testing goes.
hardtimes is offline   Reply With Quote