Mac/Terry/Mart, everyone. Don P. and I opened the side of transmission today and found everything very tight, clean and working well. Mac the rear gear on main shaft was the only one with wear on front edge. We thought that might be low?
Terry the disc is found only in one size material width, outside diameter on both are 10"
Mart, Don and I cleaned up the pressure plate with a DA sander. I borrowed his electric DA sander and cleaned up the flywheel, then wiped off the flywheel with brake cleaner, looks fine now. Will be using all the old parts EXCEPT I need a new 10" X 10 spline 1 3/8" clutch Disc, thicker the better.
.
Transmission photos for Mac's review?
.
.
transmission synchronizers
.
.
Transmission gears
.
.
Clutch pressure plate cleaned up and we adjusted fingers to a uniform height.
.
.
Flywheel cleaned up
.