Quote:
Originally Posted by KULTULZ
Were you able to ID the TRANS? . . .
|
I don't know as much as I'd like to. At the moment I can't get the car high enough off the floor to really be able to get under it.
Tried to measure "A", the length of the main case and got 10 & 1/2 inches. So not accurate enough with one hand and a tape measure???
However, at this website
http://www.charlietranny.com/Fordomatic.htm I did find an image that looks like the same pan/pan gasket, with 14 bolt holes. (photo 1 below)
The inset corner is at the front of the driver's side of the trans. The main case is cast iron.
I didn't find a picture of an air cooled Ford-O like this one on that website, but found one I took a while back.
I'll make another attempt to get underneath after I get more jackstands.