The Ford Barn - View Single Post - Mallory Unilite Distributor HELP requested.

19Fordy · 12-15-2019, 01:41 PM

Bubba, Thanks for the reply. When I use the Beru 3.3 ohm coil (with no resistor) the problem still happens. I have good grounds and the mallory 605 module test shows that it's good. Car starts with a toich of the button and runs fine for about 1/2 mile, then dies.
Restarts instantly and problem is repeated. Maybe, my problem lies elsewhere.

I sure do thank all the folks who have replied to my request for help.

12-15-2019, 01:41 PM	#13
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,925	Re: Mallory Unilite Distributor HELP requested. Bubba, Thanks for the reply. When I use the Beru 3.3 ohm coil (with no resistor) the problem still happens. I have good grounds and the mallory 605 module test shows that it's good. Car starts with a toich of the button and runs fine for about 1/2 mile, then dies. Restarts instantly and problem is repeated. Maybe, my problem lies elsewhere. I sure do thank all the folks who have replied to my request for help.