Quote:
Originally Posted by marko39
Oil returns thru two holes on side of center tube.
|
Quote:
Originally Posted by big job
Read the oil restriction orifice post topic . It will show you two .063 holes in the tube
a little under where the tube treads are. That is where the oil drains out. There is also
a .063 restriction inlet fitting. Maybe your holes are plugged up I changed a filter
this week and the little holes are visible. on 8BA Napa #1006 filter........
|
I seem to have only one hole on one side of the tube. I do not believe it is just plugged as I cleaned the tube shiny and cannot see a hole on the opposite side. So, now I am not sure what is going on. Is it possible for it to only have one hole? The engine is a '38-does that make a difference?