The Ford Barn - View Single Post - Hydraulic brakes questions

billybronco1 · 12-19-2012, 01:14 PM

Ok got the seal out - just pounded out like any seal, yes I need a new one. The bearing looks fine as the inside of the hub surfaces.

Question is - what is this washer/spacer I found on the other side, appears to be brass. Does not look like it belongs there. I'm assuming the metal I found in the drivers side hub was from a washer on this side. You can see the washer on the paper.

Keep in mind the axle nuts where not tight at all and the hubs slid right off easily

12-19-2012, 01:14 PM	#64
billybronco1 Senior Member Join Date: Dec 2012 Location: MA Posts: 570	Re: Hydraulic brakes questions - super hard pedal Ok got the seal out - just pounded out like any seal, yes I need a new one. The bearing looks fine as the inside of the hub surfaces. Question is - what is this washer/spacer I found on the other side, appears to be brass. Does not look like it belongs there. I'm assuming the metal I found in the drivers side hub was from a washer on this side. You can see the washer on the paper. Keep in mind the axle nuts where not tight at all and the hubs slid right off easily Last edited by billybronco1; 03-21-2013 at 03:48 PM.