View Single Post
Old 01-14-2018, 12:13 PM   #27
johnneilson
Senior Member
 
Join Date: Jun 2010
Location: 34.22 N 118.36 W
Posts: 1,044
Default Re: bearing insert identification help...

Rick,

I have never seen one for the numbers stamped on the shells.
Once you know the number it is easy to cross mfgrs.

more than likely the housing bore in the block is 2.146, if so it is the datsun
if it is larger, 2.162 it is a perkins/buda diesel.

there are a number of different ones as the application is not specific.

I also think there is a triumph application that gets used often.

In looking at the pics again, the radius fillet on the crank is too small, my opinion for anything more than a touring motor.

J
__________________
As Carroll Smith wrote; All Failures are Human in Origin.
johnneilson is offline   Reply With Quote