Quote:
Originally Posted by dmsfrr
Photos of that dash support bracket for a '57 Bird.
The one you have looks very much like this one except for a slight twist across the top of yours.
|
Thanks DMSFRR, that is what I was looking for.
I was not sure if the two bends on the side panels were correct.
Before I got this car it had been used as a drag racer. It had, I am told ,a rather large oldsmobile motor installed.
I have been correcting minor issues ever since, frame crossmember, firewall and tunnel sheet metal.
I am still a little gun shy when I see bent sheet metal. Thought I should inquire.
Thanks