The Ford Barn - View Single Post

flathead4rd · 03-20-2020, 02:45 PM

Had the same type of problem when I put a T-5 trans on my 50 8-BA. Trans was set at 2 degrees down and rear was set at degrees up. Still had same problem. Finally compared the input shaft yoke into the trans with an input shaft yoke for a T-5 and there was a considerable difference in length and how far it went into the trans. Swapped out the trans yokes and problem solved. You might also check the tail shaft bushing for slop.

03-20-2020, 02:45 PM	#17
flathead4rd Senior Member Join Date: May 2010 Location: Michigan Posts: 505	Re: Still vibrating but better Had the same type of problem when I put a T-5 trans on my 50 8-BA. Trans was set at 2 degrees down and rear was set at degrees up. Still had same problem. Finally compared the input shaft yoke into the trans with an input shaft yoke for a T-5 and there was a considerable difference in length and how far it went into the trans. Swapped out the trans yokes and problem solved. You might also check the tail shaft bushing for slop.