Quote:
Originally Posted by BRENT in 10-uh-C
Good reason there George!!
Why I had asked was Dan Price had cast up some saddles a few years ago and still had a couple of sets the last I checked. I almost bought a set until I found a 5-main girdle to use.
Another crank to consider is the Hercules crank out of a forklift engine. I think the bore spacing was pretty much the same and it gave a ¼"(??) stroke. Are you gonna make your own billet rods?
.
|
I will probably make my rods out of 7075. I have made some in the past.