View Single Post
Old 09-25-2014, 03:43 PM   #7
chuck stevens
Senior Member
 
chuck stevens's Avatar
 
Join Date: May 2010
Location: upstate new york
Posts: 758
Default Re: Roll back rear to do clutch

Tony, When going back together, if you are by yourself it can be a real change to roll the rear end, and line up the u-joint at the same time. I have used the small ratchet straps, two of them. One on each side of the axle, and the other ends up near the trany. You can accutually steer the rear end by ratcheting one side or the other, all the time you are up front near the u-joint. I wish I had a picture!! good luck, Chuck S.
chuck stevens is offline   Reply With Quote