[Bruce in southern OH]

Replaced oil, installed battery, re-installed the fuel pump ( works fine ) and tested carburetor with gas and sprays gas when throttle is moved. Don P. replaced the points with nos points I had and checked out on his Sun Machine and my Allen machine. Checked the condensers and showed good. I will go down to Dons and we are thinking of using old spark plug wires to start. Caps for distributor will have to be sanded to go back in distributor. Small amount of coil ignition wiring will have to be replaced because insulation is bad. Lots of little things to get done before Blast Off! I did hook up battery yesterday and turned motor with starter, starter worked good. Will have to check out the water and radiator before I go for start. Going to use the little plastic gas tank I have until I get the trunk key to look in trunk for access to top of gas tank through sending unit hole.